Products Catalogue
Contact Us
Sales office:
Room 608, Floor 6th, Liquan Building, Dongfengxi Road,
Liwan District, Guangzhou City, Guangdong Province,
China, 510180.
Factory:
Floor 3-4th, No.65, Shaluoxia Village, Dongsha Street,
Liwan District,Guangzhou City, Guangdong Province,
China, 510385.
Tel/Fax: +86-020-86534078
Mob: +86-18620181512
Contact: Joyna Chen
E-mail: joyna@www.mizucattery.com
Home > Products > Solar & Inverters > 6000W 230VAC Solar Pure Sine Wave form Inverter kit with 48V 200AH lifepo4 battery
6000W 230VAC Solar Pure Sine Wave form Inverter kit with 48V 200AH lifepo4 battery
| Model Number | FPS6048 | |||
| Inverter Mode Specification | ||||
| Output Voltage Waveform | Sine wave | |||
| Rated Output Power(VA) | 6000 | |||
| Rated Output Power(W) | 6000 | |||
| Power Factor | 0~1.0 | |||
| Nominal Output Voltage(V) | 230Vac | |||
| Nominal Output Frequency(Hz) | 50Hz±0.3Hz | |||
| Auto tracking Main Frequency(Hz) | Yes(Following Main first connection) 50Hz@45-54Hz 60Hz@55-64Hz | |||
| Output Voltage Regulation | ±10%rms | |||
| Nominal Efficiency | >80% | |||
| OverLoad Protection(SMPS load) |
(100% |
|||
| Surge rating (10s) | 18000VA | |||
| Capable of starting electric motor | 3 HP | |||
| Output Short Circuit Protection | Current limit (Fault after 10s) | |||
| Nominal DC lnput Voltage | 48V | |||
| Min DC Start Voltage | 10V/20V/40V | |||
| Low Battery Alarm |
10.5Vdc±0.3Vdc for 12V battery 21.0Vdc±0.6Vdc for 24V battery 42.0Vdc±0.6Vdc for 48V battery |
|||
| Low DC lnput Shut-down |
10.0Vdc±0.3Vdc for 12V battery 20.0Vdc±0.6Vdc for 24V battery 40.0Vdc±0.6Vdc for 48V battery |
|||
| High DC lnput Alarm Fault |
16Vdc±0.3Vdc for 12V battery 32Vdc±0.6Vdc for 24V battery 64Vdc±0.6Vdc for 48V battery |
|||
| High DC lnput Recovery |
15.5Vdc±0.3Vdc for 12V battery 31.0Vdc±0.6Vdc for 24V battery 62.0Vdc±0.6Vdc for 48V battery |
|||
| Power saver | Load≤25W(Enabled on“P/S auto”setting of Remote control) | |||
| Line Mode Specification | ||||
| Input Voltage Waveform | Sinusoidal(utility or generator) | |||
| Nominal lnput Voltage | 230Vac | |||
| Low Line Disconnect | UPS mode:180Vac±4% INV mode:160Vac±4% | |||
| Low Line Re-connect | UPS mode:190Vac±4% INV mode:170Vac±4% | |||
| High Line Disconnect | UPS mode:265Vac±4% INV mode:265Vac±4% | |||
| High Line Re-connect | UPS mode:255Vac±4% INV mode:255Vac±4% | |||
| Nominal lnput Frequency | 50Hz/60Hz (Auto detection) | |||
| Low Line Frequency Re-connect | 58±0.3Hz for 60Hz; 45±0.3Hz for 50Hz | |||
| Low Line Frequency Disconnect | 57±0.3Hz for 60Hz; 45±0.3Hz for 50Hz | |||
| High Line Frequency Re-connect | 64±0.3Hz for 60Hz; 54±0.3Hz for 50Hz | |||
| High Line Frequency Disconnect | 65±0.3Hz for 60Hz; 55±0.3Hz for 50Hz | |||
| Output Voltage Waveform | As same as lnput Waveform | |||
| Over Load Protection(SMPS load) | Circuit breaker | |||
| Output Short Circuit Protection | ||||
| Efficiency(Line Mode) | >95% | |||
| Transfer Time(AC to DC) | ≤10ms(typical) | |||
| Transfer Time(DC to AC) | ≤10ms(typical) | |||
| Charge Mode Specification | ||||
| Nominal Input Voltage | 230Vac | |||
| Input Voltage Range | UPS mode:180-265Vac±4% INV mode:160-265Vac±4% | |||
| Output Voltage Range | UPS mode:180-265Vac±4% INV mode:160-265Vac±4% | |||
| Nominal Charge Current | 45A(Max.) | |||
| Charge Current Regulation | ±5Adc | |||
| Charger ShortCircuit Protection | Circuit breaker | |||
| Over Charge Protection | Bat.V≥15.7Vdc/31.4Vdc/62.8Vdc,beeps 0.5s every 1s fault after 60s | |||
| Charge Algorithm | ||||
| Algorithm | Three stage:Boost CC (Constant current stage) Boost CV(constant voltage stage) Float(constant voltage stage) | |||
| General Specification | ||||
| Operating Temperature Range | 0℃ to 40℃ | |||
| Storage temperature | -15℃ ~ 60℃ | |||
| Operatio humidity | 5% to 95% | |||
| Audible Noise | 60dB max | |||
| Cooling | Forced air,variable speed fan | |||
| Size |
526mm*276mm*282mm |
|||
| Model Number | FSB1 | |||
| Rated voltage | 48V | |||
| Standard capacity | 200Ah | |||
| Continuously useinput current | 100A | |||
| Continuously useoutput current | 100A | |||
| Charging voltage | 57.6V—60V | |||
| Cut-off | 2.5V single cell | |||
| Self-Discharge( 25℃) | <3%/month | |||
| Depth of discharge | Up to 95% | |||
| Charge method( CC/CV ) | Operation: -20℃—70℃; Recommendation: 10℃—45℃ | |||
| Cycle life | Discharge cycle 2000 times< 1C, Discharge cycle 4000 times< 0.4C | |||
| Product Size | 580±2×646±2×379±2mm | |||
| Advantages |
1.All in one mould design and production, easy to install. 2.ith longer span life LiFePO4 battery, over 12 years lifespan, ensure the whole set products’life span. 3.Dustproof structure design, DC output, safe and reliable. 4.Integrated packaging, safe and convenient to transport |
|||
| Storage and Transportation |
1.Based on the character of cell, proper environment for transportation of LiFePO4 battery pack need to be created to protect the battery 2.Battery should be kept at -20℃—45℃ in warehouse where it’s dry, clean and well-ventilated. 3.During loading of battery, attention must be paid against dropping, turning over and serious stacking |
|||
